Weekender Rudder Gudgeon

For sharply pointed sterns After a lot of consulting with the folks at Race-Lite and with substantial help from Matt at JEM watercraft, we have finally come up with a good solution to the...

1/2" pins - 1" & 2" rudders These pintles come in two widths and with either short pin or long pin. There is no gudgeon included. All parts are stainless steel - Fits 1" or 2" thick rudder...

This is a very robust set of stainless steel rudder hardware. The vertical gudgeon that bolts against the transom is a full 1/8th (0.125) of an inch thick and 1.25" wide. The rudder gudgeons are made...

3/8" pins - 1-1/2" - 3" rudders These pintles come in several widths but only one pin length. There is no gudgeon included. All parts are stainless steel - Fits 1-1/2" through 3" thick rudders...

These gudgeons were developed for the Weekender Set, but will work with many of our 3/8" pintles. (see chart to figure out which will work) They are designed to be mounted vertically...

This set consists of two gudgeons, one short pin pintle, and one long pin pintle. There is no hold down included. All parts are stainless steel - Fits 3/4" or 1-3/8" thick rudder. (note: pintle tangs...

Medium duty stainless transom mount gudgeon from Racelite. See Particulars for dimensions. See our pintle & gudgeon compatibility chart RL-360 gudgeonMedium duty stainless steel...

See our pintle & gudgeon compatibility chart Our RL-690 rudder gudgeons are similar to our RL-490 pintles but with no pin. They can be used with the RL-690 transom pintle or...

3/8" pins - 3/4" - 1-1-4" rudders These pintles come in two widths and with either short pin or long pin. There is no gudgeon included. All parts are stainless steel - Fits 3/4" or 1-1/4" thick...

Rudders from 1/2" to 1-3/8" A set consists of two gudgeons and two pintles. The parts here are sold individually OR in sets. The parts sold individually are represented in the first chart below -...