Misc. Cleats

A Classic design in cast bronze or aluminum for you small boat (surface is a little rough, but that grips line well). Designed for halyards, clew outhauls, topping lift pennants, and other general purpose jobs. Quick to use and release. *Suited well for...

Comes with manufacturer two-year warranty Material - Inox Min line size - 3mm / 1/8" Max line size - 6mm / 1/4" Hole Spacing - 46mm / 1 13/16" Hole Diameter - 4mm / 5/32"

Easy to tension, easy to release even when wearing thick gloves. Grips the line to resist being shaken loose-even in extreme conditions. Two sizes hold a wide variety of ropes - from 0 to 5mm (0" to 3/16"). Patented toothform holds high loads without...

A deceptively simple ridged `V' groove holds ropes firmly, yet is devoid of any moving parts to break or seize. It allows the immediate release of the rope by a short upward and backward pull. Always tension the rope before it enters the cleat...

Designed for halyards, clew outhauls, topping lift pennants, and other general purpose jobs. Narrow 5/8" base. 3-1/4" long. Takes #10 screws.

V-Cleats are a simple solution to cleating lines under moderate loads.Cut away in base of fairlead cleats can be used as a becket for a 2:1 purchase system.Features:Lightweight and corrosion proofGreater abrasion resistance than traditional plastic...

Simply weave rope around cleat arms, no knots needed. Great for fender lines, trailer covers and utility lines. Fits line up to 3/8".Part#ABCDFastenerSD-0435403-1/2"15/16"1-15/16"1-3/4"1/4FH

V-Cleats are a simple solution to cleating lines under moderate loads.Cut away in base of fairlead cleats can be used as a becket for a 2:1 purchase system. Features: Lightweight and corrosion proof Greater abrasion resistance than traditional plastic...

Features65mm (2 1/2") long.18mm (11/16") wide.4mm (5/32) mounting holes.Typically used on dinghies, catamarans and small keelboatsGrade 316 stainless steelHere is a view of the cleat from the front showing the fairlead or guide:

Nylon construction with stainless steel mounting plate. Designed to mount on any 3/16" - 5/16" diameter shroud and used for tying off a halyard when not in use. Additional uses include mounting attachments for flags, solar showers, awnings, topping lift...

Features: Low friction High static and dynamic load capacity Lightweight Precision moulded Acetal sheaves running on stainless steel or Torlon® ball bearings provide high performance & low friction. Two-way head - can be fixed at 0 or 90...

FEATURES Ball bearings support the cleat arm. An integral stop prevents over rotation, but can be removed to allow full 360° rotation. The cleating angle can be set in one of two positions - use the included riser kit for a higher cleating angle. A...