Horn Cleats

A Classic design in cast bronze or aluminum for you small boat (surface is a little rough, but that grips line well). Designed for halyards, clew outhauls, topping lift pennants, and other general purpose jobs. Quick to use and release. *Suited well for...

Brass tie-down cleats are polished castings and very handsome. For the 3" and 4" cleats you have the option of ordering brass wood screws for mounting on drawers or cabinets. These are not recommended for use mounting these cleats on a boat. We...

Designed for halyards, clew outhauls, topping lift pennants, and other general purpose jobs. Narrow 5/8" base. 3-1/4" long. Takes #10 screws.

Cast Aluminum Aluminum tie-down cleats have a smoother finish than the iron, and are lighter if weight is a consideration Available in 4", 5", & 6" sizes  

Your basic black nylon tie-down cleats. They are resistant to salt and sun, and will outlast your boat. Available in 3" ,4", 5", & 6.5" sizes  

Sand Cast Bronze Cleats for any boat that aspires to a traditional look. It seems like finding bronze hardware is getting more difficult—especially pieces that don't cost as much as you paid for the boat you're putting them on! So we are pleased to...

Heavy duty black nylon tie-down cleats. They are resistant to salt and sun, and will outlast your boat. Available in 4.5, & 6.25" sizes

These die cast chrome plated cleats are interchangeable with Perko® style 1210 cleats. Complete w/ galvanized studs, washers and nuts threaded into each leg of the cleat. This eliminates the need for fasteners and provides a clean looking installation...

Cast Iron, Hot dip galvanized Part# A B C D Fastener SD-040103 3.5" 1" 13/16" 1-5/8" #8FH SD-040104 4' 1-1/8" 7/8" 1-7/8" #10FH SD-040105 5" 1-5/16" 1-1/16" 2-3/16" #12FH SD-040106 6" 1-3/8" 1-1/4" 2-3/16" 1/4"

Herreshoff style Stainless Steel tie-down cleats. They are resistant to salt and sun, and will outlast your boat. Available in 4, 5, 6, & 8 inch sizes.(Note: the Potter factory specifies the 6" SeaDog Stainless Cleat for its 15 & 19 foot...

Nylon construction with stainless steel mounting plate. Designed to mount on any 3/16" - 5/16" diameter shroud and used for tying off a halyard when not in use. Additional uses include mounting attachments for flags, solar showers, awnings, topping lift...