Sea-Dog

Most biminis have a point where a hoop hinges open or folds up flat. (See image below) These Jaw Slides do just that. Similar to our Standard Slides, but this slide opens up so it can be...

If you want to make a bimini out of square tubing or even square hardwood, you can use these fittings. Use the regular hinges. The square end cap fits 7/8" inside square tubing - 1" x 1" outside...

Cast Iron, Hot dip galvanized Part# A B C D Fastener SD-040103 3...

Stamped Brass/Molded Bakelite/10 Amps terminals Part # Terms. A B C D E Fastener SD-426604 4 7/8" 11/16" 2-3/16" 1/4" 7/16" #4 RH SD-426608 8 7/8" 11/16" 3-11/16" 1/4" 7/16" #4...

This is the best plug we've found for water ballast tanks like those found on SCAMP, as it is relatively low profile and has an easily turned T-handle. Sea-Dog says:The Garboard Drain & Plug...

Aluminum/Nylon/Acetal Anodized Aluminum - These cleats can be mounted flat or on a curved surface such as a boom (see illustration at bottom of page). Aluminum construction means these cleats will...

Quick release for rope or cable such as lifelines. These hooks are available in bronze or stainless variants.  Lately these have become popular for belts. Part No...

Stamped Brass/Injection Molded Nylon & Delrin Replace lanyard if worn, cut or frayed. Dual circuitry allows kill switch to be wired for either ignition kill or magneto kill depending on the...

Machined Brass/Injection Molded Nylon This is a typical two battery switch. It is handy for any boat with two batteries - usually where one is a starter battery and the other is a deep cycle battery...

These glass-filled injection molded nylon hinges have a stainless steel pin and are practically indestructable. They are economical too. Use them for all interior and exterior applications on your...

Sold as pairs. Sand cast brass These are very elegant round oarlocks. They would be right at home on a John Welsford Joansa, or any rowboat, for that matter. The alloy is an engineered high...

These Drain Plugs are designed with a molded-in recess in the base, thus trapping the sealant in place and providing a more water-tight seal. They also have a captive mechanism that keeps the plug in...