Sea-Dog

These bushings provide low friction rowing when used with our Zinc plated steel oarlocks. They are replacements for boats having 5/8" holes for bushings. They can also be set into holes drilled...

Stamped 304 Stainless/Injection Molded ABS - 12 Volt DC. These quality LED combination bow lights are approved by the Coast Guard and have a much lower power requirement than incandescent ones. No...

Injection molded Nylon - these are economical alternatives to our Stainless Bow Chocks. Part# A B C D Fastener SD-067360 4-1/2" 7/16" 1/2" 3-5/8" #10FH

Machined 316 Stainless Each Sea-Dog Stainless Turnbuckle is made from AISI 316 stainless steel and features an electropolished bright finish at no additional cost. All thread sizes and wire rope...

Injection Molded Rubber/Stamped 304 Stainless   A B C Fastener 2-1/4" 8-3/8" 7-11/16" #8 FH

Nylon construction with stainless steel mounting plate. Designed to mount on any 3/16" - 5/16" diameter shroud and used for tying off a halyard when not in use. Additional uses include mounting...

Injection Molded Nylon/Chrome Plated Zinc. LED Fold Down All Around Lights are approved for USCG 2NM (Colreg 2 mile). 12 Volt DC. Note: drawing is not proportional   Part...

Injection Molded Nylon

These are very elegant brass angle mount oarlock sockets. They would be right at home on a John Welsford Joansa, or any rowboat, for that matter. Not only are these premium sockets...

These drain tubes are flanged 90° on one end and fit standard 1” diameter holes. They feature an adjustable length to accommodate bulkhead installations from 3/4” up to 2-1/2”...

These are replacements for worn bushings in any of our premium brass oarlock sockets.

These Nylon drain plugs are designed to fit securely in a 1" hole without the use of fasteners. The ridges on the body of the Drain Plug are designed to keep the plug in place. Sealant should be...