RaceLite

Any line that goes through a deck needs something like this to protect both the deck and the line. Bakelite (phenolic). All pieces have approx 1/8" flange overhang and 5/8" overall height. Part # Thru Hole(min) Hole Size(for...

This set is recommended by John Welsford for Scamp. The tangs are 2-1/8 inches wide and the pintles have a sturdy 3/8" pin.This set consists of two gudgeons and two pintles. There is no hold down included. All parts are stainless steel. (note: pintle...

RL-328 - Fixed Gooseneck - Screws or rivets to standard boom and mast. Base is 1.5" x 3".Shown here with tangs

1/2" pins - 1" & 2" rudders These pintles come in two widths and with either short pin or long pin. There is no gudgeon included. All parts are stainless steel - Fits 1" or 2" thick rudder. (note: pintle tangs can be easily adjusted for rudders as...

Designed for halyards, clew outhauls, topping lift pennants, and other general purpose jobs. Narrow 5/8" base. 3-1/4" long. Takes #10 screws.

This stainless steel deck plate can be used with our RL-349 shroud adjuster or RL-305-A or RL-205 blocks. It comes complete with clevis pin and ring. wt 1/2 oz.

RL-425-H - RL-325-H Hounds are what you bolt to a mast to attach a wire stay to. These Race-Lite hounds are the ones made for various boat manufacturers. They are strong and solid. Part No. Mast Size Strap Hole...

This is a very robust set of stainless steel rudder hardware. The vertical gudgeon that bolts against the transom is a full 1/8th (0.125) of an inch thick and 1.25" wide. The rudder gudgeons are made from 1" wide strap and are 3/32 (0.090)" thick. The...

These gudgeons were developed for the Weekender Set, but will work with many of our 3/8" pintles. (see chart to figure out which will work) They can also be used on a skeg where a regular gudgeon is used as the upper pivot point. Weekender Rudder...

Reefing Hook - Mount this hook under the Tack Shackle for quick reefing - hook the reef tack under this hook. The base is 1/8" thick and 1.5" x 0.75". The two hooks are made from 1/4" dia. round stock. The mounting hole is 1/4" dia. There is a little...

Built with a stem for extra strength. Base 3" long by 1.5" wide tapering to 5/8". Stem is 4" long, 5/8" wide & 0.085" thick w/ 3 1/4" holes. Takes up to 6 #10 screws. Fin has two 1/4" holes and one 3/8" hole. All stainless steel construction.