West Wight Potter

This package (which is also suitable for many other small sloops if you adjust halyard lengths) allows the Potter 15 sailor to securely raise and lower all sails without leaving the safety of the...

Factory Potter 19 Backstay Plates. These cheeks attach to standard masthead fitting as a critical part of the backstay kit. See the PDF below for original factory installation instructions. We don't...

This Garboard Drain & Plug provides drainage for bilge during haul-out. Design includes integral 1-1/8" acetyl drain tube. Pipe plug ensures a watertight seal. Constructed of sturdy UV stabilized...

This is the factory West Wight Potter 15 and 19 gooseneck. It does not include any boom pieces, just what it pictured.

Masthead fittings for both Potter 15 and 19  

These pins are used for the mast steps on the Potter 15 and the Potter 19. Two required for each mast step.

These stainless chainplates are used for both the Potter 15 and the Potter 19.

This is the factory Potter mast step and will fit most years (some early models are different). The factory riveted the mast foot insode the mast, but 10/32 drill and tap works fine as well. Some...

Herreshoff style Stainless Steel tie-down cleats. They are resistant to salt and sun, and will outlast your boat. Available in 4, 5, 6, & 8 inch sizes.(Note: the Potter factory specifies the...

West Wight Potter-15 Factory Stem Fitting

These are the factory West Wight Potter 19 tangs - Long tangs (6") and short tangs (3")

These U-bolts are used for the chainplates on the Potter 15 and for the Baby Stay on the Potter 19