General Boat Hardware

This hinge is used to mount a bimini to a standard 7/8" rail. It connects to any of our end caps or inserts.

These die cast chrome plated cleats are interchangeable with Perko® style 1210 cleats. Complete w/ galvanized studs, washers and nuts threaded into each leg of the cleat. This eliminates the need for fasteners and provides a clean looking installation...

Sea-Dog® Stern Eyes come with adjustable finish nuts as compared to the crimped ring used on most other Stern Eyes. All parts are 304 stainless steel. Plate sizes: 2-1/4" x 3/4" (plate 1) 3-1/2" x 1-1/2" (plate 2) Part...

Stainless Steel (above)or Black (right) finish - 12 Volt DC. Now you don't have to worry about converting standard nav lights to LED. The LED's actually emit red or green light. This makes them much more effecient than putting white lights behind...

These are the bottom hinges that screw directly into a coaming or deck to mount a bimini. The photo above shows the difference between top mount and side mount and how the end caps or inserts mount on the hinges.

Injection Molded Nylon/Chrome Plated Zinc. LED Removable All Around Lights are approved for USCG 2NM (Colreg 2 mile). 12 Volt DC. Note: drawing is not proportional   Part # A B C D Fastener SD-400015 24-5/8" 18-1/2" 5/8" 2-7/8" #8FH

The Navimount Horizontal is designed to attach the Navimount Pole or the Navilights with Navimount base (model 040, 340) to horizontal surfaces - e.g. the boat deck or cabin roof. Includes- two self tapping stainless steel screws Technical Specs Size: H...

Injection Molded Nylon If you want a bimini that will easily snap out to be completely removed, and is side mounted, you may want to consider this pair. We only have them for 3/4" tubing (also fits 1/2" electrical conduit). The bracket is screwed or...

Used on the ends of bimini tubing sections These are used at the ends of the metal hoops which hold up the fabric on a bimini. We have inserts and caps for both 3/4" and 7/8" tubing. Usually Aluminum is used, but we have found that the inserts for 3/4"...

Stamped stainless steel For use where a line or wire has to pass through a deck or spar Both plates are 1-1/4" x 2" x 1/16" thick. There are four holes for #8 fasteners and they will pass up to a 3/8" line, wire or rod. The RL-255C is curved to mount on...

For replacements or new boat constructionNot sure which hatch fits your production boat? Click here for a partial list of manufacturers and hatch part numbers. Part# Outside edge of raised mounting ring Max Size * Minimum...

Once in a while you get something in the mail that is actually more robust than you had hoped rather than the other way around. That is the case with these handles. They weigh almost half a pound apiece. Solid cast brass, the SD-222356 has a polished...