General Boat Hardware

Quick release for rope or cable such as lifelines. These hooks are available in bronze or stainless variants.  Lately these have become popular for belts. Part No...

Stamped Brass/Injection Molded Nylon & Delrin Replace lanyard if worn, cut or frayed. Dual circuitry allows kill switch to be wired for either ignition kill or magneto kill depending on the application.WARNING: Test switch for proper function before...

Machined Brass/Injection Molded Nylon This is a typical two battery switch. It is handy for any boat with two batteries - usually where one is a starter battery and the other is a deep cycle battery for lights. Switch to "1" to start, to "ALL" to charge...

These glass-filled injection molded nylon hinges have a stainless steel pin and are practically indestructable. They are economical too. Use them for all interior and exterior applications on your boat - hatches, folding tables or seats, windows and much...

These access doors from DPI Marine are made from hi impact, UV stabilized, polypropylene. They have a thick rubber gasket for a good seal and all the metal parts are stainless steel. The hidden fastener doors have predrilled mounting holes that are...

Deck mounted shroud chain plate has 1/4" mounting holes on 1-1/2" centers with one 1/4" clevis pin hole. Constructed of 3/32" thick stainless steel bent to a 65 degree angle.

Stamped Stainless SteelPart No.OpeningWidthLengthFastenersRL-314-A3/8" x 3/8"3/8"3"#8RL-314-B7/16" x 7/16"1/2"3-1/2"#8RL-314-C5/8" x 5/8"1/2"3-7/8"#8

These Drain Plugs are designed with a molded-in recess in the base, thus trapping the sealant in place and providing a more water-tight seal. They also have a captive mechanism that keeps the plug in the body but still allows easy removal of the plug...

Herreshoff style Stainless Steel tie-down cleats. They are resistant to salt and sun, and will outlast your boat. Available in 4, 5, 6, & 8 inch sizes.(Note: the Potter factory specifies the 6" SeaDog Stainless Cleat for its 15 & 19 foot...

Investment Cast 316 Stainless Steel top cap for 7/8" tubing.

These stainless electropolished Anchor Hangers attach securely to any 7/8 to 1” rail or pulpit and will hold most Danforth and Fortress-style anchors up to 35 pounds, flukes down to prevent snagged lines. Allows for quick release. Easy to install...

  These are the bottom hinges that screw directly into a coaming or deck. In the picture above, you can see that the SD-273230 (left) is angled about 5-7 degrees for cambered or canted decks. The photo above shows the difference between top mount...