Rudder Hardware Sets

This set is recommended by John Welsford for Scamp. The tangs are 2-1/8 inches wide and the pintles have a sturdy 3/8" pin.This set consists of two gudgeons and two pintles. There is no hold down included. All parts are stainless steel. (note: pintle...

This is a very robust set of stainless steel rudder hardware. The vertical gudgeon that bolts against the transom is a full 1/8th (0.125) of an inch thick and 1.25" wide. The rudder gudgeons are made from 1" wide strap and are 3/32 (0.090)" thick. The...

For sharply pointed sterns After a lot of consulting with the folks at Race-Lite and with substantial help from Matt at JEM watercraft, we have finally come up with a good solution to the problem of attaching rudders to canoes and kayaks. Use two of...

See our pintle & gudgeon compatibility chart This set consists of two gudgeons, one short pin pintle, and one long pin pintle. There is no hold down included. All parts are stainless steel - Fits 3/4" or 1-3/16" thick rudder. (note: pintle tangs can...

This set consists of two gudgeons, one short pin pintle, and one long pin pintle. There is no hold down included. All parts are stainless steel - Fits 3/4" or 1-3/8" thick rudder. (note: pintle tangs can be easily adjusted for rudders as much as 1/4"...

These gudgeons are used together or with pintles having 1/4" pins. You can use a pin in each set, as in the illustration or a single pin going through all four gudgeons.Parts sold individually or as complete set. Pins not included. You may want a 1/4" SS...

See our pintle & gudgeon compatibility chart This set consists of two gudgeons and two pintles. There is no hold down included. All parts are stainless steel - Fits 1-1/2" through 3" thick rudders. (note: pintle tangs cannot be adjusted for rudder...

Rudders from 1/2" to 1-3/8" A set consists of two gudgeons and two pintles. The parts here are sold individually OR in sets. The parts sold individually are represented in the first chart below - you'll need to order two each of the rudder gudgeons and...

See our pintle & gudgeon compatibility chart This set consists of two gudgeons and two pintles. There is no hold down included. All parts are stainless steel - Fits 1-1/2" through 3" thick rudders. (note: pintle tangs cannot be adjusted for rudder...

Stainless Steel See our pintle & gudgeon compatibility chart This set consists of one gudgeon, one short pin pintle, and one long pin pintle. There is no hold down included. All parts are stainless steel - Fits 3/4" or 1-3/16" thick rudder. (note:...

See our pintle & gudgeon compatibility chart

Ideal for larger boats See our pintle & gudgeon compatibility chart This set consists of two gudgeons, one short pin pintle, and one long pin pintle. There is no hold down included. All parts are stainless steel - Fits 1" or 1-3/8" thick rudder...