SeaDog

Machined 316 Stainless Each Sea-Dog Stainless Turnbuckle is made from AISI 316 stainless steel and features an electropolished bright finish at no additional cost. All thread sizes and wire rope sizes now conform to U.S. standards and are interchangeable...

Injection Molded Rubber/Stamped 304 Stainless   A B C Fastener 2-1/4" 8-3/8" 7-11/16" #8 FH

Nylon construction with stainless steel mounting plate. Designed to mount on any 3/16" - 5/16" diameter shroud and used for tying off a halyard when not in use. Additional uses include mounting attachments for flags, solar showers, awnings, topping lift...

Injection Molded Nylon/Chrome Plated Zinc. LED Fold Down All Around Lights are approved for USCG 2NM (Colreg 2 mile). 12 Volt DC. Note: drawing is not proportional   Part # A B C D Fastener SD-400013 24" 1-7/8" 2-1/2" na #8FH

These are very elegant brass angle mount oarlock sockets. They would be right at home on a John Welsford Joansa, or any rowboat, for that matter. Not only are these premium sockets nicely finished but they come with nylon bushings. The...

These drain tubes are flanged 90° on one end and fit standard 1” diameter holes. They feature an adjustable length to accommodate bulkhead installations from 3/4” up to 2-1/2” thick. Drain tube nut locks in place for a tight,...

These are replacements for worn bushings in any of our premium brass oarlock sockets.

These Nylon drain plugs are designed to fit securely in a 1" hole without the use of fasteners. The ridges on the body of the Drain Plug are designed to keep the plug in place. Sealant should be applied prior to installation to make a watertight seal...

Stainless Steel, 4-1/2 inches long, made in Denmark. This is a special purchase available only in limited numbers.

High quality heavy cast brass strap hinges. Part# A B C D E Fastener SD-204391 4" 2" 2" 1-1/16" 3/16" #8 FH  

These injection molded nylon slam latches will secure a hinged hatch or cabinet door until you want it open at which point simply lifting the finger tab opens the latch and you can pull the hatch or door open. No need to tie hatches closed with string...