RaceLite

These gudgeons were developed for the Weekender Set, but will work with many of our 3/8" pintles. (see chart to figure out which will work) They can also be used on a skeg where a regular gudgeon is used as the upper pivot point. Weekender Rudder...

Reefing Hook - Mount this hook under the Tack Shackle for quick reefing - hook the reef tack under this hook. The base is 1/8" thick and 1.5" x 0.75". The two hooks are made from 1/4" dia. round stock. The mounting hole is 1/4" dia. There is a little...

Built with a stem for extra strength. Base 3" long by 1.5" wide tapering to 5/8". Stem is 4" long, 5/8" wide & 0.085" thick w/ 3 1/4" holes. Takes up to 6 #10 screws. Fin has two 1/4" holes and one 3/8" hole. All stainless steel construction.

For travelers, jibs, sliding stays, etc. 1/4" diameter ring. 5/8" x 3/4" opening. Slide length 3" with thumbscrew for easy adjustment. Stainless steel construction. Fits 5/8" sailtrack.

Made of spring stainless steel, these retainers are used on Sunfish and many other production sailboats to keep the daggerboard down yet allow it to be easily withdrawn. Length Width Thick 6" 3/4" 0.020"

For sharply pointed sterns After a lot of consulting with the folks at Race-Lite and with substantial help from Matt at JEM watercraft, we have finally come up with a good solution to the problem of attaching rudders to canoes and kayaks. Use two of...

Stainless hook holds pole diameters to 1-1/2". Takes #8 oval head screws.

Our RL-690 transom pintles are the same as used on most Lightning class sailboats. They are typically mounted on a flat transom and paired with a rudder gudgeon. More details under "Particulars" tab. To find out which gudgeons work with these pintles,...

See our pintle & gudgeon compatibility chart Light duty stainless transom mount gudgeon from Racelite. See Particulars for dimensions. RL-358Light duty stainless steel gudgeon 5/8" x 4" x 1/16"pin - 5/16"takes #10 fastener  

We got a special deal from Race-Lite folks on these handy little hooks. They have quite a few and gave us a big discount on them. They are one inch wide, about 1-3/4 inches long and made of 0.060" material. The holes accept #10 round head fasteners. Buy...

Stainless steel swivel. Strap is 0.06" by 3/8". 3/8"+ between tangs. 1-5/8" long over all.Takes 3/16" x 1/2" pin.

RL-250 - Fixed Gooseneck - Screws or rivets to standard boom - mounting strap is 3/4" wide and set for 2-1/2" mast but could be adjusted 1/2" either way.Shown with tangs