RaceLite

3/8" pins - 3/4" - 1-1-4" rudders These pintles come in two widths and with either short pin or long pin. There is no gudgeon included. All parts are stainless steel - Fits 3/4" or 1-1/4" thick rudder. (note: pintle tangs can be easily adjusted for...

This stainless steel deck plate can be used with our RL-305-B blocks. Takes #8 RH screws. Base 2-1/2" long. Stainless steel. You may need a 5/8" x 3/16" Clevis Pin

Stainless Steel These tangs are made from 0.062" stock and have 3/16" dia holes in the ends. The hole centers are 1/2" from the ends. Nominal lengths are not from hole centers but total overall length.

3/8" pins - 3 different options These pintles are somewhat adjustable like the Racelite 300 series pintles but heavier. You would probably want to use the narrow pintles with a metal rudder. These have a single pin length option and nominally fit a 7/16"...

Medium duty stainless transom mount gudgeon from Racelite. See Particulars for dimensions. See our pintle & gudgeon compatibility chart RL-360 gudgeonMedium duty stainless steel gudgeon thickness - 5/64"3/4" x 3-3/4" pin - 3/8"takes #10...

Stainless SteelPart #OverallSlotThicknessMtg HoleRL-344-B2" x 1"1.04" x 0.135"0.060"0.165"RL-4453" x 1.25"2.070" x 0.250"0.090"0.165"RL-4203.5" x 0.878"2.070" x 0.250"0.060"0.200"

3/8" pins - 1-1/2" - 3" rudders These pintles come in several widths but only one pin length. There is no gudgeon included. All parts are stainless steel - Fits 1-1/2" through 3" thick rudders. (note: pintle tangs cannot be adjusted for width) For...

All Stainless heliarc welded construction for extra strength. 3-1/4" long by 1-1/2" wide, tapering to 5/8" at ends. Holes take # 10 flat head screws or bolts. Fin is 2-1/2" long & 1/8" thick with (2) 1/4" holes and (1) 3/8" hole. 

The RL-318 Spin Strap from Racelite is used to connect a block to a spar or just about anywhere else. Use with block RL-305-A or RL-205. Takes #10 screws. Weighs 1/3 oz. Here it is used to attach an RL-205 to the top of the mast on our Ladybug sailboat.

See our pintle & gudgeon compatibility chart This set consists of two gudgeons and two pintles. There is no hold down included. All parts are stainless steel - Fits 1-1/2" through 3" thick rudders. (note: pintle tangs cannot be adjusted for rudder...

Stainless SteelThe stainless plates are 1-1/2" x 3" x 0.062" with 3/16" mounting holes. The curved ones are intended for a boom that is 2-3 inches in diameter.The stainless cables are 1/8" diameter x 6" long. The diameter of the button is 5/16"

RL-150-C - This is a custom gooseneck made for a Cape Cod Frosty but would work on any boat with a 1-1/4" dia mast. Shown with 1/4" boom pin