RaceLite

These gudgeons were developed for the Weekender Set, but will work with many of our 3/8" pintles. (see chart to figure out which will work) They can also be used on a skeg where a regular gudgeon is used as the upper pivot point. Weekender Rudder...

Reefing Hook - Mount this hook under the Tack Shackle for quick reefing - hook the reef tack under this hook. The base is 1/8" thick and 1.5" x 0.75". The two hooks are made from 1/4" dia. round stock. The mounting hole is 1/4" dia. There is a little...

Built with a stem for extra strength. Base 3" long by 1.5" wide tapering to 5/8". Stem is 4" long, 5/8" wide & 0.085" thick w/ 3 1/4" holes. Takes up to 6 #10 screws. Fin has two 1/4" holes and one 3/8" hole. All stainless steel construction.

For travelers, jibs, sliding stays, etc. 1/4" diameter ring. 5/8" x 3/4" opening. Slide length 3" with thumbscrew for easy adjustment. Stainless steel construction. Fits 5/8" sailtrack.

For sharply pointed sterns After a lot of consulting with the folks at Race-Lite and with substantial help from Matt at JEM watercraft, we have finally come up with a good solution to the problem of attaching rudders to canoes and kayaks. Use two of...

Stainless hook holds pole diameters to 1-1/2". Takes #8 oval head screws.

Our RL-690 transom pintles are the same as used on most Lightning class sailboats. They are typically mounted on a flat transom and paired with a rudder gudgeon. More details under "Particulars" tab. To find out which gudgeons work with these pintles,...

See our pintle & gudgeon compatibility chart Light duty stainless transom mount gudgeon from Racelite. See Particulars for dimensions. RL-358Light duty stainless steel gudgeon 5/8" x 4" x 1/16"pin - 5/16"takes #10 fastener  

We got a special deal from Race-Lite folks on these handy little hooks. They have quite a few and gave us a big discount on them. They are one inch wide, about 1-3/4 inches long and made of 0.060" material. The holes accept #10 round head fasteners. Buy...

Stainless steel swivel. Strap is 0.06" by 3/8". 3/8"+ between tangs. 1-5/8" long over all.Takes 3/16" x 1/2" pin.

RL-250 - Fixed Gooseneck - Screws or rivets to standard boom - mounting strap is 3/4" wide and set for 2-1/2" mast but could be adjusted 1/2" either way.Shown with tangs

RL-336 - Spring TypeStainless Steel spring rudder hold-down - 4" long x 3/4" wide - may be used with any of our pintles and gudgeons. RL-337 - Swivel TypeStainless Steel swivel hold-down - 1" long x 5/8" wide - may be used with any of our pintles and...