SeaDog

Quick release for rope or cable such as lifelines. These hooks are available in bronze or stainless variants.  Lately these have become popular for belts. Part No...

Stamped Brass/Injection Molded Nylon & Delrin Replace lanyard if worn, cut or frayed. Dual circuitry allows kill switch to be wired for either ignition kill or magneto kill depending on the application.WARNING: Test switch for proper function before...

Machined Brass/Injection Molded Nylon This is a typical two battery switch. It is handy for any boat with two batteries - usually where one is a starter battery and the other is a deep cycle battery for lights. Switch to "1" to start, to "ALL" to charge...

These glass-filled injection molded nylon hinges have a stainless steel pin and are practically indestructable. They are economical too. Use them for all interior and exterior applications on your boat - hatches, folding tables or seats, windows and much...

Sold as pairs. Sand cast brass These are very elegant round oarlocks. They would be right at home on a John Welsford Joansa, or any rowboat, for that matter. The alloy is an engineered high class brass for increased durability and corrosion...

These Drain Plugs are designed with a molded-in recess in the base, thus trapping the sealant in place and providing a more water-tight seal. They also have a captive mechanism that keeps the plug in the body but still allows easy removal of the plug...

Herreshoff style Stainless Steel tie-down cleats. They are resistant to salt and sun, and will outlast your boat. Available in 4, 5, 6, & 8 inch sizes.(Note: the Potter factory specifies the 6" SeaDog Stainless Cleat for its 15 & 19 foot...

Sold as pairs. These oarlocks and sockets are made of maleable iron that is heavily galvanized by the 'hot dip' method. Some say they are better than Bronze or stainless. They are certainly less expensive.

  These are the bottom hinges that screw directly into a coaming or deck. In the picture above, you can see that the SD-273230 (left) is angled about 5-7 degrees for cambered or canted decks. The photo above shows the difference between top mount...

Stamped 304 Stainless Heavy duty stamped 304 stainless steel thimbles. The smaller sizes are used to relieve wire rope where it goes around clevises, tangs, chainplates, etc. The larger sizes are typically used with rope such as on anchor lines where...

Our most economical deckplate This is a new product from Sea-Dog. Of course, deck plates are not new, but ones made of Polypropylene are. I think these may be better than the ABS ones as Polypro is more flexible and resistant to more chemicals...

These vents bring fresh air into a stuffy cabin. Can be used with a dorade box for an all-weather installation. Made from Dip Molded PVC Dia. Height Mtg. Hole Int. Color 3" 5" 3-3/4" Red