General Boat Hardware

Injection Molded Nylon/Chrome Plated Zinc. LED Fold Down All Around Lights are approved for USCG 2NM (Colreg 2 mile). 12 Volt DC. Note: drawing is not proportional   Part # A B C D Fastener SD-400013 24" 1-7/8" 2-1/2" na #8FH

Injection Molded Nylon

These drain tubes are flanged 90° on one end and fit standard 1” diameter holes. They feature an adjustable length to accommodate bulkhead installations from 3/4” up to 2-1/2” thick. Drain tube nut locks in place for a tight,...

This stopper is designed for use with the SeaLect HDPE drain tube. Cat No. A B C D K520113 15/16" 3/4" 1" 2-1/2"

Made from highly durable, UV-stabilized Polypropylene These covers are designed to cover places that only need to be exposed once in a blue moon. You have to remove the 6 screws to open them. They could be used to inspect hard to reach areas for rot or...

These Nylon drain plugs are designed to fit securely in a 1" hole without the use of fasteners. The ridges on the body of the Drain Plug are designed to keep the plug in place. Sealant should be applied prior to installation to make a watertight seal...

High quality heavy cast brass strap hinges. Part# A B C D E Fastener SD-204391 4" 2" 2" 1-1/16" 3/16" #8 FH  

C.S. Johnson Pulpit Anchor. Lots of potential uses for these stainless fittings that slip around and affix on 1" tubing of rails or pulpits, providing a ½" hole to which you can attach a block, lifeline jaw fittings, etc. This piece is a standard part...

The Navimount Vertical is designed to attach the Navimount Pole or the Navilights with Navimount base (model 040, 340) to vertical surfaces - e.g. the transom of an inflatable boat, canoe/kayak cockpit or steering console. Includes- two self tapping...

These injection molded nylon slam latches will secure a hinged hatch or cabinet door until you want it open at which point simply lifting the finger tab opens the latch and you can pull the hatch or door open. No need to tie hatches closed with string...

Features: Low friction High static and dynamic load capacity Lightweight Precision moulded Acetal sheaves running on stainless steel or Torlon® ball bearings provide high performance & low friction. Two-way head - can be fixed at 0 or 90...

FEATURES Ball bearings support the cleat arm. An integral stop prevents over rotation, but can be removed to allow full 360° rotation. The cleating angle can be set in one of two positions - use the included riser kit for a higher cleating angle. A...