Plans & Kits

Hardware and Lines Kit for Angus Sailing Rowcruiser The Duckworks part of the list of hardware bits for the Angus RowCruiser as shown on the Angus Row Boats website. A complete list of items in the kit:   Complete Set 1 3/8" Pintle and Gudgeon set...

The Power 1.3 is a development of the original Power 1 design. In this case, we were asked to produce a simply built hull with more capacity and suitable for offshore and estuary conditions. We have retained the flat bottom section which eases and...

The SAM is not suitable as a cruise boat, even if a "Spartan" sports crew might use it occasionally also for this scope - as long as it is clear that its main purpose is that of a nautical camping boat, rather than a real cruiser. The PUCK REGATA has...

This launch has been designed for diesel propulsion (10-15 hp) but she can also take steam or electric propulsion. The layout drawn for her is a simple open thro' plan with no obstructing bulkheads but she could be fitted out in a variety of ways - a...

Apparently, "Toshing" was the taking of copper from laid-up warships. We have used the Mevagissey Tosher as the model for this boat. They were renowned for their speed and sea keeping qualities and apart from removing copper they were also used for...

This design is based upon the traditional daysailers and small yachts that can be hired on the Norfolk Broads. Construction is Cedar strip planking over computer faired moulds/jig. The mast is stepped in a tabernacle for easy raising/lowering and she can...

Most East Coast Cobles were of clinker (lapstrake) construction but a few were carvel and the 27’ Northumbrian Coble emulates one of these by using modern strip planked construction. I have not attempted to ‘modernize’ the concept too much and so...

About Woods Downloadable Plans For Study Plans click HERE Specifications: cold moulded or strip plank hulls, ply decks and topsides g.r.p. production (Strider Club)LENGTH O.A. 7.3m LENGTH W.L. .6.65m BEAM O.A. 4.3mDISPL (empty) 0.7T DISPL (loaded) 1.0T...

19’6’’x 5’8’’x 11’’ (min.). May be built in two halves and bolted together as a fishing/motor dory or as a sailing dory with or without the cubby/cabin. Pre-shaped side hull panels are fastened to the...

Free Study Plans - click HERE Laura Bay Specifications Length: 9' 6"Beam: 52"Weight: 70 lbsMax Outboard: 3hpMaximum Load: 450 lbs The 9.5 Laura Bay came about from a phone conversation I had with a local yacht designer who was looking for a dingy...

Piccup Pram was the first boat of my design to get built, back in 1990, I think. I still have the prototype and use it regularly. I designed it to be the best sail/row boat I could put in the back of my short bed pick up truck. But I found it to be a...

Nootka Sound is a Camping Cruiser. It was an original design for Bob Young of Lake Oswego, Oregon, but generally similar to several earlier designs. Among the requirements were: Light weight for good trailerability with normal family cars; shoal draft;...