Paul Fisher

Snow Bunting is a river and estuary launch based upon the LIFU model hull with it's long waterline length and fairly full and buoyant ends. She has been designed for a client in Canada who wanted a seaworthy and trailable open launch. Full construction...

The Power 225 is based upon the "U" shaped hull section of our Power series of motor boats. At present we have the hull panel, frame shapes and construction details for an aluminium version of this boat - accommodation and fit-out details are not...

It had to happen of course - having designed 21' and 30' Ijssel launches, someone would want something in between and here it is. The hull is very much of the Ijssel high volume stable model with plenty of space for whatever internal arrangement you need...

The Highlander 16' dayboat was designed for a New Zealand client who wanted a rugged camping dinghy/dayboat for use around North Island. She retains the easy riding 'U' shape of the other Highlanders forward but departs from their shape in having a sharp...

13’x 6’x 8‘‘(2’9’’ with board down). A miniature cat boat of traditional design given modern construction techniques. Using the stitch and tape method with pre-shaped ply hull panels weight, cost and building...

A 27' Fishing Boat for Mr. J. Clarke - this is a high volume strip planked fishing boat of modern proportions - the drawings are for the hull construction only - the mould shapes are computer faired and her tough hull uses 2 layers of strip plank which...

These drawings show the construction details for the plywood hull only of a 55' x 15' (16.78m x 4.58m) single chine (with spray rail) 'V' bottomed motor yacht capable of speeds up to 25 or more knots. Full details including computer generated and...

Similar to the 55 footer below, we have details for the construction of a 35' steel motor yacht hull. The plans include the steel work drawings for the hull and engine beads and the computer generated hull panel shapes. She has a beam of 11'6" (3.5m)...

This is a shortened version of the 45' Teign Motor Barge and has the same flat bottom panel for maximum capacity and ease of construction. We have the plans for the hull construction in, strip plank, plywood and steel. Also note that we have now added...

This is a new design for 2001 - we were asked to reduce the length of the Waterman 13 by a foot so that she could be made in 2 boltable halves and fitted into the back of a van for transporting to the water. She was also to be the client's first venture...

Based upon the American Adironack guide boat, this craft combines traditional lapstrake (clinker) construction with modern materials. The bottom is a flat piece of 3/8’’ ply slightly rockered fore and aft and the five strakes are of...

This design is a 15' version of the 17 footer - the beam is the same at 45" and she has a single traditional oarlock. She uses just 5 sheets of 4, 5 or 6mm plywood and the plans give details so that she can be made in 2 halves split at the centre seat...