Paul Fisher

This is a 14’ (4.27m) x 4’2” (1.27m) stitch and tape/clinker/ply Thames Skiff – similar to our Thames 12 skiff - for Mr. B. Lammerton - she retains the same “wineglass” type transom and construction is for stitch &...

The Port Pegasus is a clinker boat which may be used as a pure rowing boat or fitted with a small diesel (ie Farymann 7.5) as a small motor launch with classic appearance.   As a general purpose launch, she could be fitted out in a variety of...

16’x 6’4’’x 8’’ (3’6’’ with board down). Approx. 450 lbs. lightweight with 120 lbs. of ballast. An ultra simple cruiser of double chine shape using pre-shaped ply panels for the hull. Can sleep two in...

Plans are now available here for the double ended St.Bronagh skiff designed for Tyrone Boats for coastal rowing - she has a low wetted surface area hull capable of excellent performance in offshore conditions with two crew and a cox. The plans are for...

The Power 1.3 is a development of the original Power 1 design. In this case, we were asked to produce a simply built hull with more capacity and suitable for offshore and estuary conditions. We have retained the flat bottom section which eases and...

This launch has been designed for diesel propulsion (10-15 hp) but she can also take steam or electric propulsion. The layout drawn for her is a simple open thro' plan with no obstructing bulkheads but she could be fitted out in a variety of ways - a...

Apparently, "Toshing" was the taking of copper from laid-up warships. We have used the Mevagissey Tosher as the model for this boat. They were renowned for their speed and sea keeping qualities and apart from removing copper they were also used for...

This design is based upon the traditional daysailers and small yachts that can be hired on the Norfolk Broads. Construction is Cedar strip planking over computer faired moulds/jig. The mast is stepped in a tabernacle for easy raising/lowering and she can...

Most East Coast Cobles were of clinker (lapstrake) construction but a few were carvel and the 27’ Northumbrian Coble emulates one of these by using modern strip planked construction. I have not attempted to ‘modernize’ the concept too much and so...

19’6’’x 5’8’’x 11’’ (min.). May be built in two halves and bolted together as a fishing/motor dory or as a sailing dory with or without the cubby/cabin. Pre-shaped side hull panels are fastened to the...

The JayCee was conceived with Tyrone Boats as a trainer for the International Canoe. The idea was to produce a craft which was based upon low cost, easy building techniques and which would be an introduction into the world of IC sailing. With all this...

The Loddon 20 is round bilged and can be made using foam sandwich (FRP) and strip plank Cedar construction methods. The moulds, transom and inner stem shape. She is designed for 2 or 3 rowing plus a cox or 2 rowing plus cox and passenger. The hull shape...