Sailboat Hardware

3/8" pins - 3/4" - 1-1-4" rudders These pintles come in two widths and with either short pin or long pin. There is no gudgeon included. All parts are stainless steel - Fits 3/4" or 1-1/4" thick rudder. (note: pintle tangs can be easily adjusted for...

Injection molded nylon If you have read some of the articles in Duckworks about making your own Blocks (see links below), and want to try it, but are uncertain about making the sheaves, this may be what you need. These durable Nylon pulleys are also...

This stainless steel deck plate can be used with our RL-305-B blocks. Takes #8 RH screws. Base 2-1/2" long. Stainless steel. You may need a 5/8" x 3/16" Clevis Pin

Ball bearing swivels like this one have lower friction and higher working loads than non ball bearing versions. Used in conjunction with blocks and rigging systems to provide articulation and rotation. Not suitable for high speed rotating...

Stainless Steel These tangs are made from 0.062" stock and have 3/16" dia holes in the ends. The hole centers are 1/2" from the ends. Nominal lengths are not from hole centers but total overall length.

West Wight Potter-15 Factory Stem Fitting

Features: Low friction High static and dynamic load capacity Lightweight Suitable for screw or pop rivet mounting Precision moulded Acetal sheaves running on stainless steel or Torlon® ball bearings provide high performance & low...

Make eyes in rope or wire ropeRonstan ThimblesCable Ø1/8"1/4 in.A11/32"13/16 in.B3/16"11/32 in.C5/8"1 5/16 in.Weight0.1 oz.0.7 oz.

Stamped 304 Stainless Heavy duty stamped 304 stainless steel thimbles. The smaller sizes are used to relieve wire rope where it goes around clevises, tangs, chainplates, etc. The larger sizes are typically used with rope such as on anchor lines where...

3/8" pins - 3 different options These pintles are somewhat adjustable like the Racelite 300 series pintles but heavier. You would probably want to use the narrow pintles with a metal rudder. These have a single pin length option and nominally fit a 7/16"...

If you want to install a Sea-Lect TruCourse Rudder on your boat and it does not have a standard mounting gudgeon, you will need the appropriate gudgeon. Study the photos and diagrams below to determine which model you need. Four different...

Features65mm (2 1/2") long.18mm (11/16") wide.4mm (5/32) mounting holes.Typically used on dinghies, catamarans and small keelboatsGrade 316 stainless steelHere is a view of the cleat from the front showing the fairlead or guide: