Motor Boats

The 15' Sand Martin is a simple 'V' bottomed plywood runabout/fishing boat that will comfortably take three or four people and more if required.  Construction is stitch and tape using 6mm plywood. The 15' Sand Martin may be fitted out to suit the...

Note: You will also need to purchase the Curlew plans to build this boat  This is an additional set of sketches, drawings and notes allowing the builder to construct a larger version of the Curlew adapted to be a motor sailor - the mark 2...

The Clyde 18 is a modified Power 1.3 Mk 1 design. The hull shape is a simple deadrise type, single chine 'V' bottomed. The hull is parallel sectioned aft of the wheelhouse which means that she can be easily lengthened or shortened. Construction is for...

Below are photos of Tim Thedon's Jarvis 21 under construction.               21' Jarvis Particulars LOA 21'4" 6.52m Beam (excl. gunwale rubbers) 7'9"" 2.35m Hull Mid Depth 3'4" 1...

This new design was originally drawn up for Cedar Strip construction but drawings were added later for single skin GRP construction too with the plug based on the original strip planked hull. The hull uses the classic easily driven shape of our...

The hull for this launch was originally based on our Power 16 model but instead of going for a simple flat bottom panel, we have used a 'V' bottom shape. Whilst this makes construction time a little longer it gives a slightly better ride in choppy...

This is a rugged steel workboat/fishing boat for coastal and offshore use. She has a large cockpit and enclosed wheelhouse with space below for a simple wc and/or galley. The steel hull panel shapes are given so that the hull can be...

Using between 5 and 6 sheets of 6mm ply the Sand Martin uses simple stitch and tape technology in her construction. She can be fitted out in a number of different ways but the standard arrangement shows two thwarts with side benches aft and a foredeck...

The Egret is a slightly simplified form of the Classic runabout - she has a plywood hull which can be overlaid with Mahogany veneer and teak decking to give a classic look. She has tumblehome aft and a 'V' bottomed hull with a single chine built over a...

This motorboat is based on a typical Maine Lobster boat and has been designed for strip plank construction (although she could be built using clinker/ply techniques using the same moulds). The hull has a high freeboard with flat planing sections aft and...

A slightly modern 'take' on a classic type of launch - many built in the mid 20th Century were much larger so this is a mini version. Half the launch is outside seating in an open cockpit and half is simple accommodation in the form of a couple of...

After many requests, we have extended the simple concept of the Power 1 and 2 motor launches to a length of 32' with a beam of 10'9". At the moment, the drawings for the hull and deck construction are available allowing the client to choose or design...