Rudder & Tiller

These gudgeons were developed for the Weekender Set, but will work with many of our 3/8" pintles. (see chart to figure out which will work) They are designed to be mounted vertically in cases where the boat is a double-ender or where a...

This set is recommended by John Welsford for Scamp. The tangs are 2-1/8 inches wide and the pintles have a sturdy 3/8" pin.This set consists of two gudgeons and two pintles. There is no hold down included. All parts are stainless steel. (note: pintle...

1/2" pins - 1" & 2" rudders These pintles come in two widths and with either short pin or long pin. There is no gudgeon included. All parts are stainless steel - Fits 1" or 2" thick rudder. (note: pintle tangs can be easily adjusted for rudders as...

See our pintle & gudgeon compatibility chart Our RL-690 rudder gudgeons are similar to our RL-490 pintles but with no pin. They can be used with the RL-690 transom pintle or with the RL-490 gudgeon if a bolt or rod is run through...

This is a very robust set of stainless steel rudder hardware. The vertical gudgeon that bolts against the transom is a full 1/8th (0.125) of an inch thick and 1.25" wide. The rudder gudgeons are made from 1" wide strap and are 3/32 (0.090)" thick. The...

These gudgeons were developed for the Weekender Set, but will work with many of our 3/8" pintles. (see chart to figure out which will work) They can also be used on a skeg where a regular gudgeon is used as the upper pivot point. Weekender Rudder...

For sharply pointed sterns After a lot of consulting with the folks at Race-Lite and with substantial help from Matt at JEM watercraft, we have finally come up with a good solution to the problem of attaching rudders to canoes and kayaks. Use two of...

Our RL-690 transom pintles are the same as used on most Lightning class sailboats. They are typically mounted on a flat transom and paired with a rudder gudgeon. More details under "Particulars" tab. To find out which gudgeons work with these pintles,...

See our pintle & gudgeon compatibility chart Light duty stainless transom mount gudgeon from Racelite. See Particulars for dimensions. RL-358Light duty stainless steel gudgeon 5/8" x 4" x 1/16"pin - 5/16"takes #10 fastener  

RL-336 - Spring TypeStainless Steel spring rudder hold-down - 4" long x 3/4" wide - may be used with any of our pintles and gudgeons. RL-337 - Swivel TypeStainless Steel swivel hold-down - 1" long x 5/8" wide - may be used with any of our pintles and...

See our pintle & gudgeon compatibility chart This set consists of two gudgeons, one short pin pintle, and one long pin pintle. There is no hold down included. All parts are stainless steel - Fits 3/4" or 1-3/16" thick rudder. (note: pintle tangs can...

This set consists of two gudgeons, one short pin pintle, and one long pin pintle. There is no hold down included. All parts are stainless steel - Fits 3/4" or 1-3/8" thick rudder. (note: pintle tangs can be easily adjusted for rudders as much as 1/4"...