Hardware

Made of machined 304 stainless steel. These are much nicer than our regular eyebolts. Part# A B C D E B.S. SD-080466 6 mm-1 mm 3-3/8" 1/2" 2-5/16" 1" 3K Lbs.   SD-080499   10mm - 1.5...

Stainless Steel Chainplates transfer the stress from standing rigging down into the hull. They may also have other uses for all kinds of applications. Use your imagination. Premium stainless steel made in the USA by Racelite. Cat No...

Stainless wrapped fairleads from RaceLite. The smaller one has a 5/16" opening and is suitable for 1/4" lines and smaller. The larger one has an opening of 1/2" and should not be used with line over 3/8".

Sand Cast Bronze Cleats for any boat that aspires to a traditional look. It seems like finding bronze hardware is getting more difficult—especially pieces that don't cost as much as you paid for the boat you're putting them on! So we are pleased to...

  Injection molded nylon pad eyes can be used for a multitude of applications. UV stabilized and corrosion resistant they install with two #8 FH fasteners (not included). Black

See our pintle & gudgeon compatibility chart This set consists of two gudgeons, one short pin pintle, and one long pin pintle. There is no hold down included. All parts are stainless steel - Fits 3/4" or 1-3/16" thick rudder. (note: pintle tangs can...

Use with RL-301-A or RL-301-B or RL-305-A or RL-305-B blocks. Takes #10 screws. Weight 1/3 oz.

Replacement blade only for SeaLect TruCourse Rudder.

These pins are used for the mast steps on the Potter 15 and the Potter 19. Two required for each mast step.

These commonly seen snap handle drain plugs are similar to the ones you see in Wal-Mart, but these are Stainless Steel, not zinc plated steel. They will not rust. Any reasonably smooth 1" hole in a transom or other location will work. You can install a...

V-Cleats are a simple solution to cleating lines under moderate loads.Cut away in base of fairlead cleats can be used as a becket for a 2:1 purchase system. Features: Lightweight and corrosion proof Greater abrasion resistance than traditional plastic...

This clever device is used for holding hatches open. You simply lift the hatch cover and let go. The spring snaps straight and holds the lid up without any effort on your part. To close the hatch, simply bend the spring into a "U" shape while closing...