Sea-Dog

These utility oarlocks are good for beginners as they hold the blade in position. They will clamp onto a shaft from 1-1/4 to 1-3/4 inches in diameter without modification. Mild steel construction...

Injection molded polycarbonate - 12 Volt DC. LED All Around Lights are approved for USCG 2 NM (Colreg 2 mile). Part# A B C Fastener SD-400042 4-5/16" 1-1/8" 2-1/4" #12 RH  

Injection molded nylon, these scuppers function as one-way valves to let water out of your boat but not back in. Feedback: Hi Sandra, Attached is the photo I promised of you of the scuppers...

These are very elegant ribbed horn oarlocks. They would be right at home on a John Welsford Joansa, or any rowboat, for that matter. The alloy is an engineered high class brass for increased...

Note: size = pin diameter Forged 316 Stainless Part No. A B C Breaking Strength SD-147403 5/32" 5/16" 1-1/4" 1540 lbs SD-147404 3/16" 3/8" 1" 2,200...

Made of machined 304 stainless steel. These are much nicer than our regular eyebolts. Part# A B C D E B.S. SD-080466 6 mm-1 mm 3-3/8" 1/2" 2-5/16" 1" 3K Lbs.   SD-080499   10mm - 1...

These commonly seen snap handle drain plugs are similar to the ones you see in Wal-Mart, but these are Stainless Steel, not zinc plated steel. They will not rust. Any reasonably smooth 1" hole in a...

This clever device is used for holding hatches open. You simply lift the hatch cover and let go. The spring snaps straight and holds the lid up without any effort on your part. To close the hatch,...

Note: size = diameter of pin Swivels link together two parts that have separate rotational directions reducing knotting or twisting and relieving stress. Constructed of corrosion resistant investment...

A very nice cast brass handle. Similar to the Sea-Dog Heavy Duty Lift Handle but slightly lighter and less expensive.   Part...

Injection Molded Nylon. The reason we are offering these singly rather than as a pair is that they would be ideal, I think, to mount on a transom for a sculling oar. The socket is heavily built and...

All new, patent pending design is made by way of air assist injection molding instead of foam filled method, thus preventing any potential leakage of foam from within the handle. Features ball...