Potter 15 & 19

This package (which is also suitable for many other small sloops if you adjust halyard lengths) allows the Potter 15 sailor to securely raise and lower all sails without leaving the safety of the cockpit. Want to drop jib without worrying about it...

Factory Potter 19 Backstay Plates. These cheeks attach to standard masthead fitting as a critical part of the backstay kit. See the PDF below for original factory installation instructions. We don't yet offer the other components. POTTER 19 BACKSTAY KIT...

This Garboard Drain & Plug provides drainage for bilge during haul-out. Design includes integral 1-1/8" acetyl drain tube. Pipe plug ensures a watertight seal. Constructed of sturdy UV stabilized injection molded nylon. Installs with three #8 FH...

This is the factory West Wight Potter 15 and 19 gooseneck. It does not include any boom pieces, just what it pictured.

Masthead fittings for both Potter 15 and 19  

These pins are used for the mast steps on the Potter 15 and the Potter 19. Two required for each mast step.

These stainless chainplates are used for both the Potter 15 and the Potter 19.

This is the factory Potter mast step and will fit most years (some early models are different). The factory riveted the mast foot insode the mast, but 10/32 drill and tap works fine as well. Some dimensions:   Aluminum part that goes inside the...

Herreshoff style Stainless Steel tie-down cleats. They are resistant to salt and sun, and will outlast your boat. Available in 4, 5, 6, & 8 inch sizes.(Note: the Potter factory specifies the 6" SeaDog Stainless Cleat for its 15 & 19 foot...

West Wight Potter-15 Factory Stem Fitting

These are the factory West Wight Potter 19 tangs - Long tangs (6") and short tangs (3")

These U-bolts are used for the chainplates on the Potter 15 and for the Baby Stay on the Potter 19