Motor Boats to 16'

The 15' Sand Martin is a simple 'V' bottomed plywood runabout/fishing boat that will comfortably take three or four people and more if required.  Construction is stitch and tape using 6mm plywood. The 15' Sand Martin may be fitted out to suit the...

Note: You will also need to purchase the Curlew plans to build this boat  This is an additional set of sketches, drawings and notes allowing the builder to construct a larger version of the Curlew adapted to be a motor sailor - the mark 2...

The hull for this launch was originally based on our Power 16 model but instead of going for a simple flat bottom panel, we have used a 'V' bottom shape. Whilst this makes construction time a little longer it gives a slightly better ride in choppy...

Using between 5 and 6 sheets of 6mm ply the Sand Martin uses simple stitch and tape technology in her construction. She can be fitted out in a number of different ways but the standard arrangement shows two thwarts with side benches aft and a foredeck...

This motorboat is based on a typical Maine Lobster boat and has been designed for strip plank construction (although she could be built using clinker/ply techniques using the same moulds). The hull has a high freeboard with flat planing sections aft and...

16'x5'6" ply motor launch of ultra simple construction using pre-shaped ply hull panels, frames and transom. The chine joints are completed with epoxy resin fillets and tape making construction quick. A weekend's work will see the hull panels marked out,...

The 8' Skiffle is a simple motor boat designed for children to use although she can accommodate a small adult. The hull uses a flat bottom panel with single bilge and side panels and uses simple stitch & tape methods in her construction. She can take...

The Whooping Swan is a development of the 16' Grey Swan pocket cruiser - a client asked me to alter the hull so that it would take an outboard with a wheelhouse - in doing this we have added buoyancy to the aft end and made the transom more vertical to...

This is a simple and very easily built motor dory for use with outboards up to around 50 hp in size. She can either be made by wrapping the pre-shaped sides around the frames, fastening on an external chine stringer and then putting the bottom ply on...

This design has been based upon our Northumbrian Coble designs - the client wanted a very stable seaworthy design mainly for outboard power but which could also be rowed and take a sail plan. Basic construction is for stitch and tape but the moulds/jig...

The 12'Taw is a simple 'V' bottomed plywood runabout for two people. Construction starts with the plywood frames/bulkheads being slotted onto a plywood central girder and the transom fitted. Bottom stringers are added to stiffen the bottom area...

The Harrier is a simple single chined 'V' bottomed stitch and tape ply dory for outboard power. She has been designed to give as much carrying capacity as possible in a 13' car-toppable boat making her suitable for fishing and picnicking as well as for...