Hardware

Replacement blade only for SeaLect TruCourse Rudder.

These pins are used for the mast steps on the Potter 15 and the Potter 19. Two required for each mast step.

These commonly seen snap handle drain plugs are similar to the ones you see in Wal-Mart, but these are Stainless Steel, not zinc plated steel. They will not rust. Any reasonably smooth 1" hole in a transom or other location will work. You can install a...

V-Cleats are a simple solution to cleating lines under moderate loads.Cut away in base of fairlead cleats can be used as a becket for a 2:1 purchase system. Features: Lightweight and corrosion proof Greater abrasion resistance than traditional plastic...

Note: size = diameter of pin Swivels link together two parts that have separate rotational directions reducing knotting or twisting and relieving stress. Constructed of corrosion resistant investment cast 316 stainless steel these jaw to jaw swivels are...

A very nice cast brass handle. Similar to the Sea-Dog Heavy Duty Lift Handle but slightly lighter and less expensive.   Part # A B C D E F Fastener SD-222349 6" 3-13/16" 1-1/16" 1-5/16" 3/4" 5" #10 FH

Injection Molded Polypropylene Fiberglass/Nylon These parts are used to manage shock cord on the decks of kayaks.Dimensions and specifics below Round Line Guide - K736530 A= 1.5" - B= 3/8"   Bungy Block -...

Cast Brass butt hinges for the boats that deserve or require something better than hardware store hinges...

used to convert standard footbraces to rudder control. Includes tension adjusters.  

Injection Molded Nylon. The reason we are offering these singly rather than as a pair is that they would be ideal, I think, to mount on a transom for a sculling oar. The socket is heavily built and quite strong. It will work with any of the oarlocks we...

These are the bottom hinges that screw directly into a coaming or deck. In the picture above, you can see that the SD-273230 (left) is angled about 5-7 degrees for cambered or canted decks. The photo above shows the difference between top mount and...

All Stainless heliarc welded construction for extra strength. 3-1/4" long by 1-1/2" wide, tapering to 5/8" at ends. Holes take # 10 flat head screws or bolts. Fin is 2-1/2" long & 1/8" thick with (2) 1/4" holes and (1) 3/8" hole. Complete with matching...