MSRP:
Now:
$5.04
Was:
— You save
Description
These commonly seen snap handle drain plugs are similar to the ones you see in Wal-Mart, but these are Stainless Steel, not zinc plated steel. They will not rust. Any reasonably smooth 1" hole in a transom or other location will work. You can install a section of tubing or simply line the hole with epoxy. Plug tightens by folding the handle flush as in drawing in Particulars.
See our Brass drain tubes
Cat No.
|
A
|
SD-520075
|
1"
|
Related Products

Seadog Stainless Snap Hooks
MSRP:
Now:
$2.99 - $5.99
Was:
Note: size = diameter of stock
I always called these "caribiners" but "Snap Hook" works too. Don't confuse these with the cheap, aluminum ones you see at discount and big box stores for 99¢, though...

Seadog Stainless Fixed Eye Snap Shackle
MSRP:
Now:
$10.91
Was:
Investment Cast Stainless Steel.
This is also the factory West Wight Potter halyard shackle.

Seadog Stainless T-Handle Drain Plug
MSRP:
Now:
$4.46
Was:
These commonly seen T-handle drain plugs are similar to the ones you see in Wal-Mart, but these are Stainless Steel, not zinc plated steel. They will not rust. Any 1" hole in a transome or other...
Customers Also Viewed

Seadog Stainless T-Handle Drain Plug
MSRP:
Now:
$4.46
Was:
These commonly seen T-handle drain plugs are similar to the ones you see in Wal-Mart, but these are Stainless Steel, not zinc plated steel. They will not rust. Any 1" hole in a transome or other...

Seadog Brass Drain Tube
MSRP:
Now:
$3.38
Was:
When you use either our T-handle or Snap Handle plugs you will get better results if you glue one of these brass drain tubes in first. Order plugs separately.
Cat No...

SeaLect HDPE Drain Tube
MSRP:
Now:
$2.01
Was:
This drain tube consists of two pieces, a tube with a flange on one end and another end piece with a flange. The end piece fits over the tube with a friction fit. The tube can be cut off to...

SeaLect Tapered Scupper Plug
MSRP:
Now:
$2.48
Was:
This stopper is designed for use with the SeaLect HDPE drain tube.
Cat No.
A
B
C
D
K520113
15/16"
3/4"
1"
2-1/2"

Bronze Garboard Drain & Plug
MSRP:
Now:
$16.00
Was:
This is the best plug we've found for water ballast tanks like those found on SCAMP, as it is relatively low profile and has an easily turned T-handle.
Sea-Dog says:The Garboard Drain & Plug...


Small Boat Head System
MSRP:
Now:
$9.00 - $79.00
Was:
Perfect for any small boat without a built-in head
Over the years we've tried a variety of different "heads" on small boats from fold-down seats with waste bags to chemical porta-potties and each has...

Clevis Pins
MSRP:
Now:
$0.00 - $3.93
Was:
Stainless Steel Clevis pins and rings.Pins: Example - "3/16 x 1/2" means the pin is 3/16's of an inch in diameter on the shank of the pin and there is 1/2 inch between the head and the hole. See...


Pocket Puller
MSRP:
Now:
$64.99
Was:
Our small boats fill many roles. Exercise, relaxation, exhileration, escape and sometimes we use them to put groceries in the fridge. Next crabbing season try out these Pocket Pullers from Thomas...

Rubber Sleeve
MSRP:
Now:
$24.99
Was:
Black, heat shrinkable rubber sleaves for oars. Sold as a pair, roughly 8" each with an ID of 2-1/8" prior to shrinking. Part of the Rubber Sleave Kit for XPL oars.

SeaLect Triple Latch Hatch
MSRP:
Now:
$74.95
Was:
The Sea-Lect Designs Triple Latch Hatch features 3 locking points which, when engaged, cause the camming surface to pull the lid into the gasket creating a water tight seal. The gasket also sit...