Sailboat Hardware

Injection molded Nylon Sea-Dog Nylon lateral clamcleats - mount on either side of a centerboard case, on gunwales, coaming, or other vertical surface.

This is the RL 349 adjuster for shrouds.

Takes 1/2" pintles There are two different gudgeons in this style - one two hole and one four hole - both take 1/2" pintles. Each gudgeon is actually composed of two parts as shown below. All parts are stainless steel.Typically the four hole gudgeon is...

Two sizes Use through deck fairleaders for easy and frictionless halyard entry. Large size (RL 42) fits 1" hole, is 5/8" long, and for 3/8" rope. Small size (RL 49) fits 5/8" hole, is 1/2" long, and for 5/16" rope. Part # Thru Hole(min) Hole...

Cast Iron, Hot dip galvanized Part# A B C D Fastener SD-040103 3.5" 1" 13/16" 1-5/8" #8FH SD-040104 4' 1-1/8" 7/8" 1-7/8" #10FH SD-040105 5" 1-5/16" 1-1/16" 2-3/16" #12FH SD-040106 6" 1-3/8" 1-1/4" 2-3/16" 1/4"

Aluminum/Nylon/Acetal Anodized Aluminum - These cleats can be mounted flat or on a curved surface such as a boom (see illustration at bottom of page). Aluminum construction means these cleats will stand up to more use and abuse than Nylon cleats will...

Quick release for rope or cable such as lifelines. These hooks are available in bronze or stainless variants.  Lately these have become popular for belts. Part No...

These economical yet durable camcleats from Race-Lite are just the thing for quick set and release of sheets and other lines on your sailboat. They are also handy for other jobs where precise adjustment of rope or line is needed. See also RL-261, and...

Deck mounted shroud chain plate has 1/4" mounting holes on 1-1/2" centers with one 1/4" clevis pin hole. Constructed of 3/32" thick stainless steel bent to a 65 degree angle.

Stamped Stainless SteelPart No.OpeningWidthLengthFastenersRL-314-A3/8" x 3/8"3/8"3"#8RL-314-B7/16" x 7/16"1/2"3-1/2"#8RL-314-C5/8" x 5/8"1/2"3-7/8"#8

This is the factory Potter mast step and will fit most years (some early models are different). The factory riveted the mast foot insode the mast, but 10/32 drill and tap works fine as well. Some dimensions:   Aluminum part that goes inside the...

Herreshoff style Stainless Steel tie-down cleats. They are resistant to salt and sun, and will outlast your boat. Available in 4, 5, 6, & 8 inch sizes.(Note: the Potter factory specifies the 6" SeaDog Stainless Cleat for its 15 & 19 foot...