RaceLite

For travelers, jibs, sliding stays, etc. 1/4" diameter ring. 5/8" x 3/4" opening. Slide length 3" with thumbscrew for easy adjustment. Stainless steel construction. Fits 5/8" sailtrack.

For sharply pointed sterns After a lot of consulting with the folks at Race-Lite and with substantial help from Matt at JEM watercraft, we have finally come up with a good solution to the problem of attaching rudders to canoes and kayaks. Use two of...

Stainless hook holds pole diameters to 1-1/2". Takes #8 oval head screws.

See our pintle & gudgeon compatibility chart Light duty stainless transom mount gudgeon from Racelite. See Particulars for dimensions. RL-358Light duty stainless steel gudgeon 5/8" x 4" x 1/16"pin - 5/16"takes #10 fastener  

We got a special deal from Race-Lite folks on these handy little hooks. They have quite a few and gave us a big discount on them. They are one inch wide, about 1-3/4 inches long and made of 0.060" material. The holes accept #10 round head fasteners. Buy...

Stainless steel swivel. Strap is 0.06" by 3/8". 3/8"+ between tangs. 1-5/8" long over all.Takes 3/16" x 1/2" pin.

RL-250 - Fixed Gooseneck - Screws or rivets to standard boom - mounting strap is 3/4" wide and set for 2-1/2" mast but could be adjusted 1/2" either way.Shown with tangs

RL-336 - Spring TypeStainless Steel spring rudder hold-down - 4" long x 3/4" wide - may be used with any of our pintles and gudgeons. RL-337 - Swivel TypeStainless Steel swivel hold-down - 1" long x 5/8" wide - may be used with any of our pintles and...

Stainless Steel Chainplates transfer the stress from standing rigging down into the hull. They may also have other uses for all kinds of applications. Use your imagination. Premium stainless steel made in the USA by Racelite. Cat No...

Stainless wrapped fairleads from RaceLite. The smaller one has a 5/16" opening and is suitable for 1/4" lines and smaller. The larger one has an opening of 1/2" and should not be used with line over 3/8".

See our pintle & gudgeon compatibility chart This set consists of two gudgeons, one short pin pintle, and one long pin pintle. There is no hold down included. All parts are stainless steel - Fits 3/4" or 1-3/16" thick rudder. (note: pintle tangs can...