General Boat Hardware

These are the bottom hinges that screw directly into a coaming or deck. In the picture above, you can see that the SD-273230 (left) is angled about 5-7 degrees for cambered or canted decks. The photo above shows the difference between top mount and...

Short sections of stainless steel sailtrack available for goosenecks that use it. Also for Jib sheet leads, Random mounting holes. 72 inches Max, please.   SOLD BY THE INCH

Made from highly durable, UV-stabilized Polypropylene These deckplates open easily with a 90° turn. The top covers the entire flange including fasteners for a clean look. Note: cover (not shown in diagram) is larger than the flange (B) Part No...

Fire Resistant Injection Molded Nylon/with Illuminating Switches Panel rating: 12 volt, 37 amps total. Individual circuit: 10 amps maximum. Meets CE specifications. All panels take standard glass fuses. To customize panel to your specific setup,...

These glass-filled injection molded nylon hinges have a stainless steel pin and are practically indestructable. They are economical too. Use them for all interior and exterior applications on your boat - hatches, folding tables or seats, windows and much...

These tangs are made from 0.062" stock and have 3/16" dia holes in the ends. The hole centers are 3/8" from the ends. Nominal lengths are not from hole centers but total overall length.

Replacement plug for SD-520010, SD-520020, and SD-520030

These polished cast brass pad eyes can be used for a variety of applications both decorative and functional. Great for block attachment, controlling lead lines, or creating tie down points. Installs with two #8 FH fasteners (not included). Part...

Made of 3/32" Stainless Steel with mounting holes for #10 fasteners on 1-1/2" centers, 9/16" diameter eye. RL-413A1/2in.B5/8 in.C1-1/2 in.Weight.01 lb.

Often you want a push-pull tiller extension so that you can steer the boat from up on the rail or even from the bench seat if the boat is particularly beamy. This simple swivel from Race-Lite will fill the bill. Two round head #8 or #10 screws mount it...

For fastening to aft cockpit bulkhead. Opening 2-3/4" x 3/4". Takes # 8RH screws.

Investment Cast 316 Stainless Steel. Part Number A B C SD-146131 3-5/16" 7/16" 3/4"