Mast & Boom

A Classic design in cast bronze or aluminum for you small boat (surface is a little rough, but that grips line well). Designed for halyards, clew outhauls, topping lift pennants, and other general purpose jobs. Quick to use and release. *Suited well for...

A traveler block is used to run a sheet through a block that itself runs on a rope horse.   Since 1961, Viadana has produced and supplied sailing outfits, while offering a long history of experience in research, design, manufacturing, and marketing...

Two of these stainless formed tangs constitutes a hound. The ones in the photo above are held together by a twist tie to show how they would be aligned in practice. Part No. Mast Size Strap Hole...

This curved base pad eye has a 7/16" diameter reinforced attaching hole and four 3/16" mounting holes. Stainless Steel

RL-425-H - RL-325-H Hounds are what you bolt to a mast to attach a wire stay to. These Race-Lite hounds are the ones made for various boat manufacturers. They are strong and solid. Part No. Mast Size Strap Hole...

This is the factory West Wight Potter 15 and 19 gooseneck. It does not include any boom pieces, just what it pictured.

Hardwood - Three sizes These wooden beads will work great for parrels of all kinds. The 12mm (roughly 1/2"), 16mm (roughly 5/8") and 18mm (roughly 3/4") dia beads have 5/32" holes. The 25mm (roughly 1") dia beads have 7/32" holes.

Short sections of stainless steel sailtrack available for goosenecks that use it. Also for Jib sheet leads, Random mounting holes. 72 inches Max, please.   SOLD BY THE INCH

These tangs are made from 0.062" stock and have 3/16" dia holes in the ends. The hole centers are 3/8" from the ends. Nominal lengths are not from hole centers but total overall length.

For fastening to aft cockpit bulkhead. Opening 2-3/4" x 3/4". Takes # 8RH screws.

Stamped stainless steel For use where a line or wire has to pass through a deck or spar Both plates are 1-1/4" x 2" x 1/16" thick. There are four holes for #8 fasteners and they will pass up to a 3/8" line, wire or rod. The RL-255C is curved to mount on...

This is the factory Potter mast step and will fit most years (some early models are different). The factory riveted the mast foot insode the mast, but 10/32 drill and tap works fine as well. Some dimensions:   Aluminum part that goes inside the...