SeaDog

These bushings provide low friction rowing when used with our Zinc plated steel oarlocks. They are replacements for boats having 5/8" holes for bushings. They can also be set into holes drilled directly into gunwales or wood blocks created specifically...

Stamped 304 Stainless/Injection Molded ABS - 12 Volt DC. These quality LED combination bow lights are approved by the Coast Guard and have a much lower power requirement than incandescent ones. No lenses are used, they have actual red and green bulbs for...

If you're building a new boat or replacing turnbuckles on your trailersailer, consider these top-of-the-line turnbuckles. Instead of the classic tubular style, these turnbuckles jaw/jaw turnbuckles are slightly open so you can see what's going on inside...

Machined 316 Stainless Each Sea-Dog Stainless Turnbuckle is made from AISI 316 stainless steel and features an electropolished bright finish at no additional cost. All thread sizes and wire rope sizes now conform to U.S. standards and are interchangeable...

Injection Molded Rubber/Stamped 304 Stainless   A B C Fastener 2-1/4" 8-3/8" 7-11/16" #8 FH

Nylon construction with stainless steel mounting plate. Designed to mount on any 3/16" - 5/16" diameter shroud and used for tying off a halyard when not in use. Additional uses include mounting attachments for flags, solar showers, awnings, topping lift...

Injection Molded Nylon/Chrome Plated Zinc. LED Fold Down All Around Lights are approved for USCG 2NM (Colreg 2 mile). 12 Volt DC. Note: drawing is not proportional   Part # A B C D Fastener SD-400013 24" 1-7/8" 2-1/2" na #8FH

These are very elegant brass angle mount oarlock sockets. They would be right at home on a John Welsford Joansa, or any rowboat, for that matter. Not only are these premium sockets nicely finished but they come with nylon bushings. The...

These are replacements for worn bushings in any of our premium brass oarlock sockets.

These Nylon drain plugs are designed to fit securely in a 1" hole without the use of fasteners. The ridges on the body of the Drain Plug are designed to keep the plug in place. Sealant should be applied prior to installation to make a watertight seal...

Stainless Steel, 4-1/2 inches long, made in Denmark. This is a special purchase available only in limited numbers.