Cleats & Chocks

Sand Cast Bronze Cleats for any boat that aspires to a traditional look. It seems like finding bronze hardware is getting more difficult—especially pieces that don't cost as much as you paid for the boat you're putting them on! So we are pleased to...

V-Cleats are a simple solution to cleating lines under moderate loads.Cut away in base of fairlead cleats can be used as a becket for a 2:1 purchase system. Features: Lightweight and corrosion proof Greater abrasion resistance than traditional plastic...

Heavy duty black nylon tie-down cleats. They are resistant to salt and sun, and will outlast your boat. Available in 4.5, & 6.25" sizes

These die cast chrome plated cleats are interchangeable with Perko® style 1210 cleats. Complete w/ galvanized studs, washers and nuts threaded into each leg of the cleat. This eliminates the need for fasteners and provides a clean looking installation...

Keep anchor or dock lines from chafing gunwale or other parts of your boat. Investment Cast 316 Stainless - these are hefty, high quality parts. They will look good on any boat.Part#ABCDFastenerSD-0600404-3/4"13/16"1/2"3-5/16"#10FH

Cast Iron, Hot dip galvanized Part# A B C D Fastener SD-040103 3.5" 1" 13/16" 1-5/8" #8FH SD-040104 4' 1-1/8" 7/8" 1-7/8" #10FH SD-040105 5" 1-5/16" 1-1/16" 2-3/16" #12FH SD-040106 6" 1-3/8" 1-1/4" 2-3/16" 1/4"

Herreshoff style Stainless Steel tie-down cleats. They are resistant to salt and sun, and will outlast your boat. Available in 4, 5, 6, & 8 inch sizes.(Note: the Potter factory specifies the 6" SeaDog Stainless Cleat for its 15 & 19 foot...

Features65mm (2 1/2") long.18mm (11/16") wide.4mm (5/32) mounting holes.Typically used on dinghies, catamarans and small keelboatsGrade 316 stainless steelHere is a view of the cleat from the front showing the fairlead or guide:

Keep anchor or dock lines from chafing the gunwale or other parts of your boat. Sand cast bronze finish - these are hefty, high quality parts. Specifications FINISH Cast Finish MATERIAL Bronze OVERALL LENGTH 6 in OVERALL HEIGHT 1-7/8 in BASE...

Injection molded Nylon - these are economical alternatives to our Stainless Bow Chocks. Part# A B C D Fastener SD-067360 4-1/2" 7/16" 1/2" 3-5/8" #10FH

Nylon construction with stainless steel mounting plate. Designed to mount on any 3/16" - 5/16" diameter shroud and used for tying off a halyard when not in use. Additional uses include mounting attachments for flags, solar showers, awnings, topping lift...

Features: Low friction High static and dynamic load capacity Lightweight Precision moulded Acetal sheaves running on stainless steel or Torlon® ball bearings provide high performance & low friction. Two-way head - can be fixed at 0 or 90...