Hardware

27.12 Details: Pin size - 4mm / 5/32" Inside Width - 10mm / 3/8" Inside Height 15mm / 9/16" Breaking Load - 700 kg / 1,543 lbs   27.14 Details Pin size - 5mm / 3/16" Inside Width - 12mm / 1/2" Inside Height 17mm / 11/16" Breaking Load - 1,050 kg /...

Sold in pairs.   These oarlocks and sockets are made of maleable iron that is heavily galvanized by the 'hot dip' method. Some say they are better than Bronze or stainless. They are certainly less expensive.

These oarlocks and sockets are made of maleable iron that is heavily galvanized by the 'hot dip' method. Some say they are better than Bronze or stainless. They are certainly less expensive. Sockets are either angle mount or top mount...

These are the bottom hinges that screw directly into a coaming or deck. In the picture above, you can see that the SD-273230 (left) is angled about 5-7 degrees for cambered or canted decks. The photo above shows the difference between top mount and side...

These are used at the ends of the metal hoops which hold up the fabric on a bimini. We have inserts and caps for both 3/4" and 7/8" tubing. Usually Aluminum is used, but we have found that the inserts for 3/4" tubing are almost a perfect fit in 1/2 steel...

Cast Brass butt hinges for the boats that deserve or require something better than hardware store hinges. Part# A B C D E Fastener SD-204526 1-1/2" 3/4" 3/4" 2-3/4" 1/16" #6 FH SD-204526L 1-1/2" 3/4" 3/4" 2-3/4" 1/16" #6 FH

Cast Brass butt hinges for the boats that deserve or require something better than hardware store hinges. Part# A B C D E Fastener SD-204516 1-1/2" 3/4" 3/4" 2" 1/16" #6 FH SD-204516L 1-1/2" 3/4" 3/4" 2" 1/16" #6 FH

The hinge is designed to be mounted on the front surface of a raised door. Stamped 304 Stainless

A high quality stamped 304 Stainless Steel hinge at an economy price. Takes 5 #8 flat head fasteners.

Easy to tension, easy to release even when wearing thick gloves. Grips the line to resist being shaken loose-even in extreme conditions. Two sizes hold a wide variety of ropes - from 0 to 5mm (0" to 3/16"). Patented toothform holds high loads without...

A deceptively simple ridged `V' groove holds ropes firmly, yet is devoid of any moving parts to break or seize. It allows the immediate release of the rope by a short upward and backward pull. Always tension the rope before it enters the cleat...

This set is recommended by John Welsford for Scamp. The tangs are 2-1/8 inches wide and the pintles have a sturdy 3/8" pin.This set consists of two gudgeons and two pintles. There is no hold down included. All parts are stainless steel. (note: pintle...