Sailboat Hardware

Deck mounted shroud chain plate has 1/4" mounting holes on 1-1/2" centers with one 1/4" clevis pin hole. Constructed of 3/32" thick stainless steel bent to a 65 degree angle.

Stamped Stainless SteelPart No.OpeningWidthLengthFastenersRL-314-A3/8" x 3/8"3/8"3"#8RL-314-B7/16" x 7/16"1/2"3-1/2"#8RL-314-C5/8" x 5/8"1/2"3-7/8"#8

This is the factory Potter mast step and will fit most years (some early models are different). The factory riveted the mast foot insode the mast, but 10/32 drill and tap works fine as well. Some dimensions:   Aluminum part that goes inside the...

Clevis pins and rings can get hooked on line or otherwise pulled out and consequences can be disastrous. On stayed rigging we suggest wrapping your turnbuckles and other pinned fittings to make sure they don't get snagged or wiggle lose—especially if...

Herreshoff style Stainless Steel tie-down cleats. They are resistant to salt and sun, and will outlast your boat. Available in 4, 5, 6, & 8 inch sizes.(Note: the Potter factory specifies the 6" SeaDog Stainless Cleat for its 15 & 19 foot...

3/8" pins - 3/4" - 1-1-4" rudders These pintles come in two widths and with either short pin or long pin. There is no gudgeon included. All parts are stainless steel - Fits 3/4" or 1-1/4" thick rudder. (note: pintle tangs can be easily adjusted for...

RL-327 - slides on 5/8" sailtrack for easy adjustment, and has a a thumbscrew to stop travel. Shown with tangs.

This stainless steel deck plate can be used with our RL-305-B blocks. Takes #8 RH screws. Base 2-1/2" long. Stainless steel. You may need a 5/8" x 3/16" Clevis Pin

Ball bearing swivels like this one have lower friction and higher working loads than non ball bearing versions. Used in conjunction with blocks and rigging systems to provide articulation and rotation. Not suitable for high speed rotating...

Stainless Steel These tangs are made from 0.062" stock and have 3/16" dia holes in the ends. The hole centers are 1/2" from the ends. Nominal lengths are not from hole centers but total overall length.

West Wight Potter-15 Factory Stem Fitting

Features: Low friction High static and dynamic load capacity Lightweight Suitable for screw or pop rivet mounting Precision moulded Acetal sheaves running on stainless steel or Torlon® ball bearings provide high performance & low...