Hardware

These access doors from DPI Marine are made from hi impact, UV stabilized, polypropylene. They have a thick rubber gasket for a good seal and all the metal parts are stainless steel. The hidden fastener doors have predrilled mounting holes that are...

Deck mounted shroud chain plate has 1/4" mounting holes on 1-1/2" centers with one 1/4" clevis pin hole. Constructed of 3/32" thick stainless steel bent to a 65 degree angle.

Recommended Tool for Raptor 18 Gauge Composite Brads The 12.20P brad nailer drives Raptor 18 gauge composite brads from 7/16" through 3/4" in length. Model OMER 12.20P Fastener range 7/16"; 5/8"; 3/4" (11; 16; 20mm) Magazine capacity 100...

Sold as pairs. Sand cast brass These are very elegant round oarlocks. They would be right at home on a John Welsford Joansa, or any rowboat, for that matter. The alloy is an engineered high class brass for increased durability and corrosion...

Thru Hole Fluted, Threaded Knobs Rubber, Stainless insert These knobs have all sorts of uses for DIYers in general and boatbuilders in particular. The thread is either 1/4-20 or 3/8-16, and they both have stainless steel inserts. The smaller size fit...

Stamped Stainless SteelPart No.OpeningWidthLengthFastenersRL-314-A3/8" x 3/8"3/8"3"#8RL-314-B7/16" x 7/16"1/2"3-1/2"#8RL-314-C5/8" x 5/8"1/2"3-7/8"#8

These Drain Plugs are designed with a molded-in recess in the base, thus trapping the sealant in place and providing a more water-tight seal. They also have a captive mechanism that keeps the plug in the body but still allows easy removal of the plug...

This is the factory Potter mast step and will fit most years (some early models are different). The factory riveted the mast foot insode the mast, but 10/32 drill and tap works fine as well. Some dimensions:   Aluminum part that goes inside the...

Clevis pins and rings can get hooked on line or otherwise pulled out and consequences can be disastrous. On stayed rigging we suggest wrapping your turnbuckles and other pinned fittings to make sure they don't get snagged or wiggle lose—especially if...

Herreshoff style Stainless Steel tie-down cleats. They are resistant to salt and sun, and will outlast your boat. Available in 4, 5, 6, & 8 inch sizes.(Note: the Potter factory specifies the 6" SeaDog Stainless Cleat for its 15 & 19 foot...

When you don't want to mount your footbraces by drilling a hole through your kayak, simply fiberglass or glue on studs to act as the mounting bracket. This kit includes four studs, four clamps, four nylock nuts and two cable adjuster clamps. This kit...

3/8" pins - 3/4" - 1-1-4" rudders These pintles come in two widths and with either short pin or long pin. There is no gudgeon included. All parts are stainless steel - Fits 3/4" or 1-1/4" thick rudder. (note: pintle tangs can be easily adjusted for...