Hardware

These replacement latch kits for access doors from DPI Marine are for the DPF and DPH Series hatches only - they do not work for the round Pull Up DPI deck plates. Kit Includes: 1 x Pull Handle 1 x Cam Shaft 1 x O ring 1 x...

Stamped Brass/Molded Bakelite/10 Amps terminals Part # Terms. A B C D E Fastener SD-426604 4 7/8" 11/16" 2-3/16" 1/4" 7/16" #4 RH SD-426608 8 7/8" 11/16" 3-11/16" 1/4" 7/16" #4 RH   Stamped Brass/Molded Bakelite/20 Amps...

This is the best plug we've found for water ballast tanks like those found on SCAMP, as it is relatively low profile and has an easily turned T-handle. Sea-Dog says:The Garboard Drain & Plug provides drainage for bilge during haul-out. 1/2" NPT...

5/16" pins - 3/4" - 1-3/16" rudders These pintles come in two widths and with either short pin or long pin. There is no gudgeon included. All parts are stainless steel - Fits 3/4" or 1-3/16" thick rudder. (note: pintle tangs can be easily adjusted for...

Aluminum/Nylon/Acetal Anodized Aluminum - These cleats can be mounted flat or on a curved surface such as a boom (see illustration at bottom of page). Aluminum construction means these cleats will stand up to more use and abuse than Nylon cleats will...

Quick release for rope or cable such as lifelines. These hooks are available in bronze or stainless variants.  Lately these have become popular for belts. Part No...

Stamped Brass/Injection Molded Nylon & Delrin Replace lanyard if worn, cut or frayed. Dual circuitry allows kill switch to be wired for either ignition kill or magneto kill depending on the application.WARNING: Test switch for proper function before...

Machined Brass/Injection Molded Nylon This is a typical two battery switch. It is handy for any boat with two batteries - usually where one is a starter battery and the other is a deep cycle battery for lights. Switch to "1" to start, to "ALL" to charge...

See our pintle & gudgeon compatibility chart This set consists of two gudgeons and two pintles. There is no hold down included. All parts are stainless steel - Fits 1-1/2" through 3" thick rudders. (note: pintle tangs cannot be adjusted for rudder...

These glass-filled injection molded nylon hinges have a stainless steel pin and are practically indestructable. They are economical too. Use them for all interior and exterior applications on your boat - hatches, folding tables or seats, windows and much...

These economical yet durable camcleats from Race-Lite are just the thing for quick set and release of sheets and other lines on your sailboat. They are also handy for other jobs where precise adjustment of rope or line is needed. See also RL-261, and...

The strong reliable standard for external sail tracks. Attach with stainless shackles or lace them on. Fits 5/8" external sail track. You may want to use our sailmaker's D-shackles rather than lace or stitch these slides to your sail.