Motor Boats

The Chaffinch is a trad sterned narrow boat - drawings give the computer faired and generated hull panel shapes and full details for steel construction. The steel work drawings give details for the FW tank, rudder, sterngear/engine installation and weed...

A 20' Beaver sterned electric launch - for simplified plywood construction using pre-shaped ply fore and aft girders and frames which slot together to give the basic shape accurately. 20' Pup...

The Stour 23 has a simple 'V' bottomed hull form giving an easily driven shape that is also faster to build. Construction starts with a simple arrangement of plywood frames and bulkheads slotted together on a plywood central girder. Chine stringers are...

We have construction details for the hulls only of two 1930's style motor yachts. The first, shown above has a LOD of 60' (18.3m), beam of 13'11" (4.24m), draft of 3'8" (1.10m) and displacement of 30 tons (30.4 tonnes) and uses a simple form of ply...

The plans for the 16' Henley Slipper Launch include the hull panel shapes for a single chine "V" bottomed version and we were simply asked to take this model and stretch it to 18' - however, instead of just developing the hull panels, we have completed a...

We have often been asked about the design of a more rakish runabout - built in much the same way as the Redshrike (a ply inner skin over frames covered with Mahogany veneer) but with more modern lines - and at last we have been asked to design one...

I have recently drawn up the steel work/construction drawing along with the frame and plate shapes for a steel multi-chine version of the 45' Teign Motor Barge. We can also send details for the rudder engine beds etc for the 45' version as guidance for...

The Power 1.2 is a development of our Power 1 design. She has increased beam and the chine has been lowered to give a more stable shape so that her side decks can be used comfortably. The drawings give details for a cabin arrangement with 2 full length...

The Ruby 19 is based on our Ruby 22 double chine plywood steam launch. In the case of the Ruby 19 a client wanted a shorter version of the 22 to be built in steel which meant widening and deepening her to take the steel weight. Having produced the...

This is a very simple stitch and tape design using 5 sheets of 9mm (3/8") ply with pre-shaped hull panels and transoms. With a beam of 4'6" and a mid depth of 16" she has plenty of room for fishing, camping or for family pic-nics.She may be rowed but is...

The RUFUS 17 plans have included the hull panel and frame shapes for a 20' x 8' version which were requested as a modification. I have now taken the 20' details and added a full set of plans for this version including hull construction details, deck...

This is a general purpose 26' workboat with a beam of 8'4". Construction consists of pre-shaped ply bulkheads and girders which are slotted together. Chine girders are then fitted and the pre-shaped hull skin then applied. Details are shown for the...